Altered Art Projects: Prepping and Decorating Books, Tins and Boxes
On the table
- A hardcover book with sewn pages, a metal tin or a small box
- Sandpaper or a sanding sponge, 220 grit
- Rubbing alcohol and a lint-free cloth
- Spray primer for metal (for tins)
- White gesso
- Soft gel medium or matte medium
- Craft knife with fresh blades and a metal ruler
- Binder clips or two heavy books for pressing
- Matte acrylic varnish
The paint peeling off a finished tin a week later is the most common altered art disappointment, and it has nothing to do with the paint. Every found object comes with a surface made for its first life: a glossy book jacket, a lacquered mint tin, a waxed cigar box, printed cardboard with a plastic coating. None of them is made to hold gesso. The work that decides whether an altered piece lasts happens before the first color goes on, and it differs for each material.
Altered art borrows every layer from flat mixed media work but puts them on an object with edges, hinges and a spine that all have to keep working.
Surface prep at a glance
| Surface | Problem | Prep before gesso or paint |
|---|---|---|
| Cloth book cover | Absorbent, frays at corners | One coat of gel medium to seal the weave, then gesso |
| Glossy dust jacket or laminated cover | Slick, gesso peels | Remove the jacket; sand the cover until the shine is gone |
| Book pages | Thin, wrinkle when wet | Glue into thicker pages first, then gesso thinly |
| Metal tin | Oily, nonporous | Alcohol, 220 grit scuff, metal primer |
| Varnished wooden box | Sealed, paint beads | Sand to dull the finish, wipe off dust |
| Raw wood | Drinks the first coat | Light sanding, one coat of gesso, sand, second coat |
| Printed cardboard box | Plastic coating, warps when wet | Sand lightly, two thin gesso coats, dry flat under weight |
Altered books
Pick the book by its binding before its content. A hardcover with sewn signatures, the small bundles of folded pages you can see stitched at the top of the spine, holds up to paint and collage. A paperback with a glued spine cracks once the pages get heavy and starts shedding them.
An altered book swells as you work. Every collage layer, every coat of gesso adds thickness, and a book that closed flat at the start ends up gaping like a clam. Tear or cut out some pages before you begin. Removing every third or fourth page leaves room, and cutting close to the spine with a craft knife leaves a narrow stub that keeps the stitching tight.
Single book pages are too thin to carry paint. Glue them into groups of three to five with soft gel medium or a glue stick, smoothing each one from the spine toward the outer edge, then dry the book closed with wax paper between each new thick page and something heavy on top. The result is a stiff board that takes gesso and collage without rippling.
Cutting a niche
A niche is a recessed box cut into the text block, sized for a small object, a photo or a folded note.
- Clip the front cover and the first few pages out of the way.
- Brush watered-down PVA glue or gel medium along the three outer edges of the remaining text block and clamp it closed with binder clips until dry.
- Draw the niche on the top page, leaving at least 3/4 inch of border on every side.
- Cut along a metal ruler with a fresh craft knife blade in many shallow passes. Lift out a few pages at a time as they come free.
- Change blades often. A dull blade tears paper fibers and leaves a ragged wall.
- Brush gel medium over the cut walls to bind them into a solid block, then line the niche with paper or paint once dry.
A niche deeper than about an inch takes patience more than skill. It is a long evening of shallow cuts.
Tins
Small hinged mint tins are the classic altered tin, because they are free and fit in a pocket. Wash the tin with dish soap, dry it, then wipe every outside surface with rubbing alcohol to remove oil and fingerprints. Scuff the lacquer with 220 grit sandpaper until it looks dull all over, and spray one light coat of primer for metal. From there gesso, paint, collage and stamping all hold.
Keep the hinge and the rim of the lid bare. Paint and paper on the lip of a tin rub against each other, and after a few openings the lid either jams or scrapes the decoration off. Mask the hinge with painter’s tape while priming.
For embellishments on metal, a gel medium is too weak. Use a strong craft glue rated for metal, and let it cure for the full time printed on the tube before handling.
Boxes
Cigar boxes, small wooden crates and lidded papier-mâché boxes all work, and the chipboard used for album covers takes the same prep. The mini albums guide shows how chipboard pages are bound, and an altered box with a little album inside its lid is a natural pairing.
Wooden boxes with a varnished surface need sanding until the shine is gone; raw wood needs only a light pass. Printed cardboard shows its coating as a slight sheen, and it warps if gesso goes on thick, so build two thin coats and let the box dry with something flat inside it to hold the sides square.
Edges, hinges and the finish
Edges are where an altered piece looks either worn in or simply worn out. Sand the corners of a book cover or box lightly after painting, then run an ink pad along them so the edges darken the way a handled object does. The methods from distressing paper work on painted chipboard and wood as well.
Seal last, and only once everything is dry through. A thin coat of matte acrylic varnish brushed in one direction protects the surface; on a book, varnish the cover and the page edges but leave the inside of the spine free so it still bends. Then stand the book upright and fanned open for a full day before closing it, or the varnished pages glue themselves together.
Questions crafters ask
What kind of book is best to alter?
A hardcover with sewn signatures and thick, matte pages. The stitching survives heavy collage, while a glued paperback spine cracks and drops pages.
Will paint stick to a metal tin?
Only after prep. Degrease with rubbing alcohol, scuff the surface with 220 grit sandpaper, and spray a thin coat of primer made for metal before gesso or acrylic paint.
How do I stop glued book pages from wrinkling?
Use a thin, even coat of gel medium or a glue stick instead of watery glue, smooth the pages from the spine outward, and dry the book closed under weight with wax paper between the glued sections.
Does altered art need to be sealed?
Anything handled often does. A thin coat of matte acrylic varnish over the finished surface protects paper edges and ink from fingerprints and moisture.
More in Mixed Media Art Techniques for Beginners, From the Gesso Ground to Distressed Edges